Lights installation and testing

Drilling holes using the stepping drill bit.

LED fitted inside a plastic LED holder. This helps in keeping the LEDs firmly attached to the case.

View of the assembly from the back

Quick test to ensure all LEDs are working
Due to ambient lighting the LEDs seem a bit on the purple side.

Test with the bezel in place. Notice - the buttons module is now flipped upside down. The large power button is where Badtz-Maru will be placed. I have omitted one LED over the lower flower, the one between two hearts on the left. A defuser will be placed over the two LEDs, which will ensure even illumination.

No comments:

Post a Comment